Sticker Application Guide

A vinyl decal is only as good as the twenty minutes you spend putting it on. Work in shade, on a cool panel, and do not rush the last step.

What you need

  • Soap, water and a clean cloth
  • Isopropyl alcohol, or any clean spirit
  • Masking tape
  • A squeegee, or a credit card wrapped in a thin cloth

Step by step

  1. Wash the panel. Soap and water first, then dry it completely. Wax, polish and road film all stop the adhesive from gripping.
  2. Wipe with alcohol. Go over the exact spot with isopropyl alcohol and let it flash off. Do not touch the area afterwards; skin oil is enough to lift an edge later.
  3. Position it dry. Hold the decal where you want it, step back and check it. Then tape one edge down as a hinge so it cannot move.
  4. Peel the backing at a shallow angle. Pull the backing paper away from the decal, not the decal away from the paper. Keep the angle tight so small details stay on the transfer tape.
  5. Squeegee from the centre out. Short overlapping strokes, working air towards the edges. Firm pressure, not heavy.
  6. Wait, then peel the transfer tape. Give it a few minutes. Peel the tape back on itself at a tight angle, almost flat against the panel. If a letter starts to lift, lay the tape back down, squeegee that spot again and try once more.

The first week

  • Keep the panel out of rain for 24 hours.
  • No pressure washer on the edges for a week. After that, keep the lance at least 30 cm away and never aim straight at an edge.
  • The adhesive reaches full strength after about 72 hours.

Fixing common problems

Air bubbles. Small ones usually disappear within a few days in the sun. For a larger one, prick the edge of the bubble with a pin and press the air out towards the hole.

An edge lifting. Lift it slightly, clean underneath with alcohol, let it dry, then press it down and hold for thirty seconds.

It went on crooked. Within the first few minutes you can usually lift it slowly and reposition it. After an hour, warm it gently with a hair dryer first.

Removing a sticker

Warm the decal with a hair dryer for about thirty seconds, lift a corner with a fingernail, and peel it back against itself at a tight angle. Pull slowly. Any adhesive left behind comes off with isopropyl alcohol and a cloth. Removed this way, cured factory paint is not affected.

Surfaces that do not work

Vinyl will not hold on fresh paint that has not cured, on textured or porous plastic, on a rusted panel, or on a surface that gets hotter than an exhaust shield. Matte wrap and PPF are fine, but tell us first so we send a lower-tack adhesive.